[widar-wg] widar reboot pending

[Michael Rupen]

So far as I can tell all the boards are working (i.e., C_quad* and X_osro 
scripts give the expected results), except the two boards noted
below.

          Michael

> All boards are now running PCMC firmware V2.8.
> This allows use of higher speed data transfers to the dumptrig HES
> generators.
>
> Casualties:
> b108-b-6 has a failed Accel reguator (x1y4)
> s005-b-6 cannot program delay module 1. This could be due to timing
> signal issues or a bad module (the second delay module often gives
> failed programming indications when there are clock issues).
>
> -Bruce
>
>
>
>
> On Jun 23, 2011, at 9:50 AM, Bruce Rowen wrote:
>
>> Widar will be rebooted then power cycled to install the new PCMC
>> binary. I expect this will take about 1 hour (1000 - 1100 MDT).
>>
>> -Bruce
>> ________________________________________________________________________________
>> There is a web page, used as a document repository, associated with
>> this list.
>> The URL for the web page is:
>> http://listmgr.cv.nrao.edu/pipermail/widar-wg/
>
> ________________________________________________________________________________
> There is a web page, used as a document repository, associated with this list.
> The URL for the web page is:
> http://listmgr.cv.nrao.edu/pipermail/widar-wg/
>