[daip] Re: AC757 data
Eric Greisen
egreisen at nrao.edu
Thu Dec 2 13:00:09 EST 2004
Nicholas Cross writes:
> I have been away for a while and also had other work to get on
> with, so I wasn't able to properly look at this until now. I found that
> the interval was 8s in the TY table, so I edited the CPARM(9) parameter
> (9 => TY table time incr. min) in the FILLM parameters to 0.08333 (5s),
> but this doesn't appear to change in the TY table. Are there other
> parameters that I need to change too?
Did you re-run FILLM? What does PRTAB show in the TY table? What
adverbs did you use for EDITA? What version of AIPS are you using?
I need information if I am to help you.
ERic Greisen
> Nick
>
> On Fri, 5 Nov 2004, Eric Greisen wrote:
>
> > Data Analysts writes:
> >
> > > Dear Meri,
> > > I am having problems with EDITA. I was trying to edit the
> > > calibrator data in the channel-0 data set, but I got the following
> > > message and no plots appeared (the boxes for the 7 antennae appeared but
> > > no data was shown).
> > >
> > > ACS41 > EDITA1: Task EDITA (release of 31DEC04) begins
> > > ACS41 > EDITA1: Tant columns are not good, using Tsys columns
> > > ACS41 > EDITA1: All data will reside in memory
> > > ACS41 > EDITA1: Found -4 times, stored on a time axis of length 4
> > > ACS41 > EDITA1: Computing difference data, then plotting
> > > ACS41 > EDITA1: Press buttons A, B, or C to choose an operation
> > > ACS41 > EDITA1: Press button D for on-line help
> > >
> > > Cheers,
> > > Nick.
> >
> > To debug what is happening you should look at the TY table with PRTAB.
> > Are there any rows matching the other adverbs to EDITA such as times,
> > antennas, FQs, Subarrays, etc?
> >
> > Note that FILLM allows you to set a TY table interval. For EDITA it
> > is especially helpful for that to be small.
> >
> > Eric Greisen
> >
More information about the Daip
mailing list