[daip] VLBI questions
Eric Greisen
egreisen at nrao.edu
Thu Sep 13 16:18:14 EDT 2007
Cheng-Yu Kuo writes:
> 1. In our observations, there are 8 IF bands in total. When loading
> the data from the tape to the disk with FITLD in AIPS, AIPS sorted
> the data into two frequency IDs. Each freqID contains 4 IF bands.
> However, out of our expection, there is almost no data in the second
> freqID, so we are missing almost half of the data. We do try to use UVPLT
> to show the data of the second IF, but the amount of the data is just
> much much less than it should be. Maybe it is the problem when the data
> was correlated? Or because we did load the data properly?
Can you send us (daip) the headers of the data sets and the output
of LISTR OPCODE='SCAN'? Programs like UVPLT have many adverbs that
limit which data are seen and not seen and so may appear to suggest
that data are missing when they are not...
>
>
> 2. The other problem is the following: We used 12 antennas to make
> our VLBI observations. When we looked into the GC and TY tables, the
> information of all the antennas are there. However, when we printed
> the antenna table (AN), there are only 11 antennas. The antenna in
> St. Croix is missing. We are not sure about this problem as well.
>
Out VLBI ewxpert will get back to you but I am sure that she will need
this information.
Eric Greisen
More information about the Daip
mailing list