[daip] pn3db
Eric Greisen
egreisen at nrao.edu
Fri Aug 13 11:50:58 EDT 2004
Data Analysts writes:
>
> OK. That worked fine. But now it's aborting with:
>
> aspen > CALIB2: Task CALIB (release of 31DEC04) begins
> aspen > CALIB2: CALIB USING PN3DB.040811 . X BAND . 1 DISK= 1 USID= 13
> aspen > CALIB2: Selecting the data
> aspen > CALIB2: Doing cal transfer mode with point model for each source
> aspen > CALIB2: This is not self-calibration
> aspen > CALIB2: Dividing data by source flux densities
> aspen > CALIB2: Determining solutions
> aspen > CALIB2: Writing SN table 2
> aspen > CALIB2: Found 1462 good solutions
> aspen > CALIB2: Failed on 4080 solutions
> aspen > CALIB2: 2154 solutions had insufficient data
Your data seem to be messed up rather badly! I will take a
bit of a look...
Eric
> aspen > CALIB2: Adjusting solutions to a common reference antenna
> aspen > CALIB2: Appears to have ended successfully
> aspen > CALIB2: aspen 31DEC04 TST: Cpu= 9.4 Real= 16
> aspen > PN3PL2: Task PN3PL (release of 31DEC04) begins
> aspen > PN3PL2: ZTXOP2: using translated file name =
> aspen > PN3PL2: ZTXOP2: /DATA/ASPEN_1/FITS/PN3DB.LOG
> aspen > PN3PL2: PLOT FILE VERSION 1 CREATED.
> aspen > PN3PL2: AZ SCAN> AZ1,2: 130.10 135.21 EL1,2: 59.41 61.42
> aspen > PN3PL2: MEAN, SLOPE, AMP1, FI1, ERR: 0.931 6.125 3.172 102.820.194
> aspen > PN3PL2: AMP2, FI2, ERR: 1.340 -75.9 8.546
> aspen > PN3PL2: ZABORS: signal 8 received
> aspen > PN3PL2: ABORT!
>
>
> >
> > type
> >
> > compress
> >
> > and the new symbol will be recognized.
> >
> > Eric
> >
More information about the Daip
mailing list