[daip] Problem in CALIB
Eric Greisen
egreisen at nrao.edu
Mon Apr 21 15:18:05 EDT 2008
Poonam Chandra wrote:
> Hi,
> I am analysing a VLA continuum D array data. I am at the stage of
> running CALIB. I could run CALIB successfully on the flux calibrator.
> However, it gives error while running the phase calibrator. I check the
> data. It looks okay to me. Where I am going wrong?
> sasha.> CALIB1: Task CALIB (release of 31DEC07) begins
> sasha.> CALIB1: CALIB USING 20070301 . X BAND . 1 DISK= 1 USID=2559
> sasha.> CALIB1: UVGET: Using flag table version 1 to edit data
> sasha.> CALIB1: Selecting and editing the data
> sasha.> CALIB1: Doing cal transfer mode with point model for each source
> sasha.> CALIB1: This is not self-calibration
> sasha.> CALIB1: Dividing data by source flux densities
> sasha.> CALIB1: Determining solutions using amp-scalar averaging
> sasha.> CALIB1: Writing SN table 2
> sasha.> CALIB1: RPOL, IF= 1 The average gain over these antennas is
> 0.000E+00
> sasha.> CALIB1: RPOL, IF= 2 The average gain over these antennas is
> 0.000E+00
> sasha.> CALIB1: LPOL, IF= 1 The average gain over these antennas is
> 0.000E+00
> sasha.> CALIB1: LPOL, IF= 2 The average gain over these antennas is
> 0.000E+00
> sasha.> CALIB1: ERROR: NO VALID SOLUTIONS FOUND
There is no information here from which I can deduce anything. CALIB
seems to have found no data. Try UVPRT with the same adverbs plus
DOCRT=1 to see if some other task finds data.
Eric Greisen
More information about the Daip
mailing list