[daip] fillm problem

[Eric Greisen]

Data Analysts writes:

 >   we ran into an odd FILLM problem when loading AC713 15mar04 data.  When
 > loading with no time range AIPS reports finding data on both the
 > calibrator and the source, but no calibrator data appear in LISTR/SCAN
 > (even if one runs INDXR later).  If one sets a time range to start loading
 > data a few minutes into the file (at midnight...), the resulting data set is
 > fine.  There were odd things going on at the VLA (ANTSOL crashed, timing
 > problems, etc. etc. -- check Pat Van Buskirk for details) so this sort of
 > strange behavior is perhaps not surprising.
 > 
The data are not on the publec ftp site - so I have not been able to
check into this.  It is possible that the antsol failures caused the
data to be marked as bad and so fillm notes the header but loads no
data.

Let me know if you want this followed up - and where the data are to
do so.

Eric Greisen