[daip] multiple images models for UVCON

[Leonia Kogan]

Aaron,

>endeav> UVCON1: The fourth character in the IN2CLASS can not be a digit!

This restriction was correct for the old representation of the images.

Now it is not right.

I'll remove it from the code now and the new version of UVCON will be available 
through the MNJ tomorrow.

Leonia



----- Begin Included Message -----

>From owner-daip at kochab.cv.nrao.edu Wed Apr  4 12:43 MDT 2001
X-Mailer: exmh version 2.1.1 10/15/1999
To: daip at cv3.cv.nrao.edu
cc: cohen at rsd.nrl.navy.mil
Subject: [daip] multiple images models for UVCON
Mime-Version: 1.0
Date: Wed, 04 Apr 2001 14:42:06 -0400
From: Aaron Cohen <cohen at omaha.nrl.navy.mil>
Sender: owner-daip at kochab.cv.nrao.edu
Precedence: bulk
X-Lines: 43
Status: RO

Dear Designated Aip,

I would like to use UVCON with a model that consists of a 
few hundred facets, each with its own CC table.  The facets 
are named as follows:

AIPS 1:  345 2000 XMM-UVC     .ICL001.    1 MA 04-APR-2001 14:17:40
AIPS 1:  346 2000 XMM-UVC     .ICL002.    1 MA 04-APR-2001 14:17:40
AIPS 1:  347 2000 XMM-UVC     .ICL003.    1 MA 04-APR-2001 14:17:40
... up to ...
AIPS 1:  685 2000 XMM-UVC     .ICL341.    1 MA 04-APR-2001 13:43:55

I first ran UVCON with the parameters:

...
AIPS 1: IN2NAME    'XMM-UVC     '          Model image name (name)
AIPS 1: IN2CLASS   'ICL001'                Model image name (class)
AIPS 1: IN2SEQ        1                    Model image name (seq. #)
AIPS 1: IN2DISK       9                    Model image disk unit #
...
AIPS 1: NMAPS       341                    No. maps to use for model.
...

This is how I would input a model into CALIB for example.  However with 
UVCON I received the following error:

endeav> UVCON1: Task UVCON  (release of 31DEC01) begins
endeav> UVCON1: The fourth character in the IN2CLASS can not be a digit!
endeav> UVCON1: Purports to die of UNNATURAL causes
endeav> UVCON1: endeavour    31DEC01 TST: Cpu=       0.0  Real=       0

I then tried leaving IN2CLASS blank and got:

endeav> UVCON1: ERROR  5 FINDING XMM-UVC     .ICL00A.  1     DISK=  9 USID=2000

So apparently this won't work for more than 9 facets.

Please let me know if you have any ideas on how I can use UVCON with
a model with many ( > 9 ) facets.

Thanks,
-Aaron



----- End Included Message -----