Hi Rick,<div>For point 2 - we were bitten again by the use of the combination of dwell time in the OPT and array time in the</div><div>model-to-script. I set this up to run the night before using array time to provide some flexibility in case of earlier</div>

<div>failures or needing to shift the observation (e.g., to support observing it 5 minutes off the UV-grid you had before).</div><div>However, the slews for the dwell time would have been calculated at the time of the model-to-script conversion</div>

<div>so completely inappropriate for when it was run.</div><div>Given that dwell times are not often used, we (I) need a warning when this mode is being employed so we don't</div><div>stumble on this again.</div><div>

The other CBE/lustre issues need to be summarized.</div><div>Joe </div><div><br><div class="gmail_quote">On Mon, Mar 7, 2011 at 3:50 PM, Rick Perley <span dir="ltr"><<a href="mailto:rperley@nrao.edu">rperley@nrao.edu</a>></span> wrote:<br>

<blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex;">    The 9.5 hour observation of Herc-A taken last night was not a major<br>
success.  Many odd things occurred.<br>
<br>
    1) The most obvious failure is a nearly 4-hour gap in the archive,<br>
from 12:56 IAT through 16:37 IAT.<br>
<br>
    2) A more subtle problem is the lack of visibility data from both<br>
polarization calibrators, 3C286 and J1504+1029.  Observations of these<br>
sources required moderate to large slews.  It is clear after careful<br>
examination that the system greatly underestimated slew times.  I<br>
utilized the 'on source' timing in the OPT -- this worked beautifully<br>
for the massive 'flux densities' run, but has failed in the Herc A run.<br>
In general, since I used a loop through the bands such that S-band was<br>
always observed last, I did get S-band data for most of the polarization<br>
calibration attempts.<br>
<br>
    3) There are blocks of missing scans.  The first occurred on the<br>
initial observation of 3C286 -- the L and X band observations are<br>
present, but the following observations at C-band and S-band are<br>
completely missing (and there is a 3 minute time gap corresponding to<br>
where  the data should have been).  Data flowed again on the following<br>
L-band scan.  The IAT times for this gap are 07:52:22 through 07:55:33 (<br>
00:52 through 00:55 in local time).<br>
    Later on, a much larger gap -- 10 minutes occurred, again following<br>
a X-band observation (when the next observation would be at C-band).<br>
The time range here was 09:02:17 to 09:12:48.<br>
<br>
<br>
<br>
_______________________________________________<br>
evlatests mailing list<br>
<a href="mailto:evlatests@listmgr.cv.nrao.edu">evlatests@listmgr.cv.nrao.edu</a><br>
<a href="http://listmgr.cv.nrao.edu/mailman/listinfo/evlatests" target="_blank">http://listmgr.cv.nrao.edu/mailman/listinfo/evlatests</a><br>
<br>
</blockquote></div><br><br clear="all"><br>-- <br>Dr. Joseph P. McMullin         <br>EVLA                             <br>Ph: +1 575 835 7315<br>E-mail: <a href="mailto:jmcmulli@nrao.edu" target="_blank">jmcmulli@nrao.edu</a><br>

<a href="http://science.nrao.edu/evla/" target="_blank">http://science.nrao.edu/evla/</a><br><br>
</div>